How To Use The Appliance - GEHA A4 Comfort Manual De Instrucciones

HOW TO USE THE APPLIANCE

• We do not recommend laminating any type of self-developing photo.
• Any photo to be laminated must be dry before processing.
• Do not laminate any documents that appear thick or heavy, as they will get stuck in
the laminator. If this occurs, please contact your local service centre for servicing.
• This product bonds the laminate sleeve to the items processed. It is a permanent
seal and cannot be removed.
• We do not recommend laminating any collector's items of value or any item you
may wish to remove at a later date. Do not attempt to laminate coins or thicker items.
1 Housing
2 Indicator
3 Anti-block system (ABS)
4 Rear Exit
5 Laminating insert
6 Power switch
7 Temperature adjustor
1. Using the temperature adjustor, select the desired temperature.
2. Start the device by pressing the power switch.
3. a) If you have set the device to hot laminating (80 mic. or 100-125 mic.), the red
indicator light is on. The laminator is heated up. As soon as the red indicator light is
off and the blue indicator light is on, the device is ready for hot laminating. It takes
about 3 to 5 minutes for the device to heat up to the required temperature.
b) If you have chosen cold laminating (Cold), the blue indicator light is on immediately
and the device is ready for operation. If you wish to cold laminate with the hot
laminator, turn the temperature adjustor to "Cold" and wait 3 hours until the
laminator has cooled down. As soon as the red indicator light is off and the blue
indicator light is on, the device is ready for cold laminating.
4. Place the item to be laminated into the laminating sleeve, centring it within the sleeve.
Please make sure your document or picture is positioned as close to the sealed
edge as possible.
8
fig. 1