Operation - Milwaukee M4910-20 Manual Del Operador

INSTALLING NOZZLE TIP GUARD ON
DUAL-ACTION™ PISTOL-GRIP SPRAYER
See Figures 6 - 7.
See operator's instructions for flushing, priming, and cleaning
before installing a spray tip. Note all warnings regarding use
of DUAL-ACTION™ pistol-grip sprayer and the possibility
of injection.
 Push the lock-off lever down to lock the sprayer trig-
ger.
 Unscrew the nozzle tip guard.
NOTE: Small parts inside the tip guard can be easily
dropped and misplaced. Always remove the nozzle tip
guard carefully.
 Insert tip sleeve into the nozzle tip guard while aligning
the holes.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury .
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ACCESSORIES
All accessories used with this product must be rated greater
than 3200 psi. Ensure compatibility and fit before using any
accessory with this product.
WARNING:
Risk of fire or explosion - spray area must be well
ventilated and away from spark of flames. Failure to heed
this warning could result in serious personal injury.
ASSEMBLY
 Insert the desired reversible spray tip into the nozzle tip
guard, locking the sleeve into place.
 Insert metal saddle into the nozzle tip guard. The metal
saddle should be securely seated on the reversible spray
tip.
 Insert the rubber seal ridged side down onto the saddle
in the nozzle tip guard.
 Thread nozzle tip guard assembly onto sprayer and tighten
securely.
 Push spray tip securely into nozzle tip guard.
 Keep the sprayer trigger locked when not in use.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Exterior painting and staining of decks, outdoor furniture,
fences, siding, and interior/exterior spray-painting of
walls, cabinets, and doors.
WARNING:
To reduce the risk of injection NEVER change spray tip
without setting the lock-off on the pistol-grip sprayer and
NEVER point sprayer at any part of the body, persons, or
unit itself. In case of skin injection, seek medical attention
immediately. Failure to heed this warning may cause
serious personal injury.
LOCKING THE DUAL-ACTION
SPRAYER
See Figure 6.
Always lock the sprayer trigger when you have stopped
spraying to prevent the sprayer from being bumped or
triggered accidentally and causing injection.
 Push the lock-off lever down to lock the sprayer trig-
ger.
 Push the lock-off lever toward the handle to unlock the
trigger.
RELEASE PRESSURE PROCEDURE
See Figure 8.
Always follow this procedure when shutting the airless/finish
paint sprayer OFF for any reason. This procedure releases
pressure in the high pressure hose.
 Push the lock-off lever down to lock the sprayer trigger.
 Turn HI/OFF/FINISH switch OFF.
9 — English
PISTOL-GRIP
™