Installing And Removing The Battery And Card - Canon EOS Rebel T7 Manual De Instrucciones Básicas

Installing and Removing the Battery and Card

Load a fully charged Battery Pack LP-E10 into the camera. You can use
an SD, SDHC, or SDXC memory card (sold separately) with the
camera. The captured images are recorded onto the card.
Make sure the card's write-protect switch is set upward to
enable writing and erasing.
Installing the Battery and Card
Write-protect switch
Possible shots
28
Open the cover.
1
Slide the lever as shown by the

arrows and open the cover.
Insert the battery.
2
Insert the end with the electrical

contacts.
Insert the battery until it locks in

place.
Insert the card.
3
As shown by the illustration, face

the card's label side toward the
back of the camera and insert it
until it clicks in place.
Close the cover.
4
Press the cover until it snaps shut.

When you set the power switch to

<1>, the number of possible shots
will be displayed on the LCD monitor.