Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
•
1
Instruction Manual
6
Wooden Shelves
1
Wire Shelf
2
Glass Shelves
2
Handles
Before connecting this appliance to the power source, let it stand upright for approximately 2
•
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
•
INSTALLATION OF YOUR APPLIANCE
This appliance is designed to be for free standing installation or built-in (fully recessed).
•
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To
•
level your appliance, adjust the front leveling legs at the bottom of the appliance.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
•
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
•
Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under
•
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application please follow the requirements shown to the right.
INSTALLATION INSTRUCTIONS
Cabinet Opening Dimensions
IN (min)
Width
24
Depth
24
Height
34 ½
8
CM (min)
61
61
87.6
Publicidad
Tabla de contenido
