Avanti DW18 Manual De Instrucciones página 16

glassware. much detergent.
Too high inlet water temperature.
Yellow or brown film Tea or coffee stains.
on inside surfaces.
Iron deposits in water can cause an
overall film.
White film on inside Hard water minerals.
surfaces.
Detergent left in Dishes block detergent cups.
dispenser cups.
Steam This is normal.
Black or gray marks Aluminum utensils have rubbed
on dishes. against dishes.
Water standing in the This is normal.
bottom of the tub.
Water doesn't pump Drain is clogged.
out of the tub.
Dishwasher leaks. Overfill dispenser or rinse aid spills.
Dishwasher isn't level.
Spots and filming on Extremely hard water
glasses and flatware Low inlet water temperature
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent
prevent this from happening, use less
detergent if you have soft water. Wash
glassware in the shortest cycle that will get
them clean.
Make sure inlet water temperature is correct.
Using a solution of ½ cup bleach and 3 cups
warm water to remove the stains by hand.
Warning: Before cleaning interior wait at
least 20 minutes after a cycle for the heating
elements to cool down. Failure to do so can
result in burns.
A special filter in the water supply line is the
only way to correct this problem. Contact a
water softener company for a special filter.
To clean the interior, apply dishwasher
detergent to a damp sponge. Wear rubber
gloves. Do NOT use any other cleaner than
dishwasher detergent for the risk of foaming
or suds.
Re-load the dishes properly.
Steam comes through the vent during
washing, drying and when water is being
pumped out.
Remove marks with a mild, abrasive cleaner.
A small amount of clean water around the
outlet on the tub bottom at the back of the tub
keeps the water seal lubricated.
If you have an air gap, clean it.
Make sure the kitchen sink is draining well.
If the dishwasher drains into a disposer, run it
clear.
Be careful not to overfill the rinse aid
dispenser. Spilled rinse aid could cause
oversudsing and lead to overflowing. Wipe
away any spills with a damp cloth.
Make sure the dishwasher is level.
To remove stubborn spots and pre-existing
film from glassware:
1. Remove all metal utensils from the
dishwasher.
2. Do not add detergent.
3. Choose the HEAVY cycles.
4. Start the dishwasher and allow to run for
30 minutes. Dishwasher will now be in
the main wash.
5. Open the door and pour 2 cups (500ml)
of white vinegar into the bottom of the
dishwasher.
6. Close the door and allow to complete the
cycle. If vinegar rinse doesn't work:
16