Carburettor; Adjusting The Idle Speed (T); Maintenance; Air FIlter - Husqvarna 533RS Manual De Instrucciones

H1158941-30,533-553RS,WestII.fm Page 25 Tuesday, July 4, 2017 8:19 AM

Carburettor

Adjusting the idle speed (T)

Check that the air filter is clean. When the idle speed is
correct, the cutting attachment should not rotate. If
adjustment is required, close (turn clockwise) the idle
adjustment screw T, with the engine running, until the
cutting attachment starts to rotate. Open (turn
anticlockwise) the screw until the cutting attachment
stops. The idle speed is correctly set when the engine
runs smoothly in all positions, and there is a clear margin
to the speed at which the cutting attachment starts to
rotate.
(533RS)
(543RS, 553RS)
WARNING! If the idle speed cannot be
!
adjusted so that the cutting attachment
stops, contact your dealer/service
workshop. Do not use the machine until
it has been correctly adjusted or
repaired.

MAINTENANCE

Air filter
The air filter must be regularly cleaned to remove dust
and dirt in order to avoid:
• Carburettor malfunctions.
• Starting problems.
• Loss of engine power.
• Unnecessary wear to engine parts.
• Excessive fuel consumption.
(533RS)
(543RS, 553RS)
Clean the filter every 25 hours, or more regularly if
conditions are exceptionally dusty.
Cleaning the air filter
(543RS, 553RS)
Remove the air filter cover and take out the filter. Blow
clean with compressed air.
(533RS)
Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water. Ensure that the filter is dry
before refitting it.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
553RS
543RS
English
–
25