To Apply Air Filter Oil To The Air Filter; To Apply Grease To The Two-Piece Shaft; To Clean The Air Filter - Husqvarna 122C Manual De Usuario

3. Clean the spark plug if it is dirty. Make sure that the
electrode gap is correct. Refer to
page 17 .
4. Replace the spark plug when it is necessary.

To apply grease to the two-piece shaft

• Apply grease to the end of the drive shaft after each
30 hours of operation.

To clean the air filter

1. Remove the air filter cover and remove the air filter.
2. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
3. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
941 - 004 - 10.04.2019
Technical data on
4. If your product has a foam air filter, apply air filter oil.
Only apply air filter oil to a foam filter. Do not apply
oil to a felt filter.

To apply air filter oil to the air filter

CAUTION: Always use special air filter oil on
foam air filters. Do not use other types of oil.
WARNING: Do not get oil on your body.
1. Remove the air filter cover and remove the air filter.
2. Put the air filter in a plastic bag.
3. Put the air filter oil in the plastic bag.
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove the
air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
15