INSTALL WHEEL KIT
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install this wheel kit:
• 1/2" or 13mm socket wrench
• 1/2" or 13mm open end wrench
• 7/16" socket wrench
• 7/16" open end wrench
• Needle-nose pliers
NOTE: Adjustable wrenches may be substituted for open
end wrenches.
Refer to Figure 2 and install the wheel kit as follows:
1.
Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease assembly.
2.
Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 2.
Figure 2 — Install Wheel Kit
Use existing hardware
to attach left side of
support leg to unit
Hex Nut
Support Leg
Vibration Mount
Capscrew
3.
Slide a wheel over the axle.
4.
Slide a flat washer over the axle and place the e-ring
onto the groove in the axle.
5.
Place one end of the needle nose pliers on the bottom
of the axle and the other end of the pliers on top of
the e-ring. Seat the e-ring by pressing the pliers closed.
6.
Repeat step 3 through 5 to secure second wheel.
7.
Remove the temporary blocks.
8.
Attach the vibration mounts to the support leg with
1/4-20 x 1" capscrews and 1/4-20 lock nuts.
9.
To aid support leg assembly, rest generator on cradle,
engine end down. Remove the existing locknut from
the left unit vibration mount with 13mm wrench. Use
the same locknut to attach the support leg.
10. Attach the other side of the support leg with a M8 x
20 mm capscrew and M8 lock nut. Rest generator on
wheels and support leg.
11. Check each fastener to ensure it is secure.
Axle
Capscrew
Hex Nut
7
Section 3: Assembly
Wheel
Flat Washer
E-Ring