Publicidad
Idiomas disponibles
Idiomas disponibles
Indicators
The indicators allow checking the status and notify you of abnormal operation of the projector.
If the projector exhibits abnormal status, address the problem in accordance with the table
below.
ON/STANDBY indicator
Status
Lights in red
Flashes in green
Lights in green
Lights in orange
Flashes in red
Flashes twice
Flashes six times
Other number of
flashes
LAMP/COVER indicator
Status
Flashes in red
Flashes twice
Flashes three times The temperature of the lamp is unusually high. Turn off the projector
22
GB
Indicators
Meaning/Remedies
The projector is in Standby mode.
• The projector is ready to operate after having been turned on.
• The lamp cools after the projector is turned off.
The projector's power is on.
The projector is in AUTO POWER SAVING (lamp cut off).
The projector is in abnormal status. Symptoms are indicated by
number of flashes. Address the problem in accordance with the
following. If the symptom is shown again, consult with qualified Sony
personnel.
The internal temperature is unusually high. Check the items below.
• Check to see if nothing is blocking the ventilation holes.
• Check to see if the air filter is not clogged. (page 25)
Unplug the AC power cord from a wall outlet. After checking that the
ON/STANDBY indicator goes out, plug the power cord to a wall
outlet again then turn on the projector. If the problem still persists,
consult with qualified Sony personnel.
Consult with qualified Sony personnel.
Meaning/Remedies
Symptoms are indicated by number of flashes. Address the problem in
accordance with the following.
The lamp cover or air filter cover is not attached securely. (page 23,
25)
and turn it on again after the lamp has cooled. If the same symptom
occurs, turn off the projector again and remove the lamp (page 23),
then check if the lamp is not broken.
If the lamp is not broken, reattach the lamp and turn on the projector
again.
If the symptom occurs again, the lamp may be exhausted. In this case,
replace the lamp with a new one (page 23).
If the lamp is broken, do not exchange the lamp by yourself. Consult a
qualified Sony consultant.
Publicidad
