Rollator B
| Rollator
4.
Assembly/adjustments
4.1. Fitting push handles
•
Remove the marked protective sleeves from the tube (Fig 4).
•
Insert the push handles into the handlholds and fix them using the
wing screw.
•
Please observe the minimum insertion depth (knurled area)
4
(section 4.5).
4.2.
Unfolding
•
Position the rollator in the travel direction.
•
Release the locking brakes (see sec. 4.5).
•
Tip the B+B rollator towards yourself until the load is taken off the
steered wheels and press the handles downwards at the same time
5
with a gentle jolt.
•
To lock the folding mechanism, now fold the seat plate tight to
your seat (Fig. 4). This locks the rollator.
4.3.
Folding
•
Position the rollator in the travel direction.
•
Activate the locking brakes.
6
•
Hold the rollator firmly with both hands and tilt it by pulling it
towards you.
•
For unlocking, take one hand off the handle and use it to activate
7
the lever of the auto-lock system (Fig. 7). Ensure that neither body
parts nor pieces of clothing become pinched during the folding
process.
•
To fold the rollator up completely, pull the handles towards you.
30
Note that the rollator may suddenly fold up when
the lever is activated.
4.4.
Attach basket and tray
•
The rollator is unfolded. Activate the locking brakes.
•
Position yourself against the travel direction in front of the rollator.
•
Simply hang the basket onto the hooks attached to the front frame
tubes (Fig. 8)
•
To remove the basket, simply grasp the carrying handle and pull it
up and off.
•
Place the tray onto the seat from above in such a way that the four
plastic pins of the tray fit into the holes of the seat (Fig. 9).
4.5.
Adjusting the push handles
•
The rollator is unfolded. Activate the locking brakes.
•
Turn the plastic lever on the handholds until the handles move
freely (Fig. 10).
•
Position yourself behind the B+B rollator and allow your arms to
hang loosely downwards.
•
Now adjust the push handles so that they are located at the height
of your wrists. Select the nearest hole in the push tube.
•
Retighten the plastic lever after the adjustment procedure. Observe
the minimum insertion depth. (knurled area)
•
Repeat this procedure on the other side.
•
Check to make sure that both the push handles are at the same
height.
•
The push handles may be turned a maximum of 0° outwards.
Bischoff & Bischoff GmbH | 16.09.2019 - Revision: 1
Rollator B
Rollator |
8
9
10
11
31