Installation; Before Starting; Installation Cautions - Clarion GR10BT Manual De Usuario Y Manual De Instalacion

9. INSTALLATION

1. Before Starting

1. This set is exclusively for use in vessels with a negative ground
12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "–" terminal before starting.
This is to prevent short circuits during installation. (Figure 1)

2. Installation Cautions

1. In order to avoid any interference, do not install the tuner module or control unit in the
proximity of the engine compartment.
2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning on the unit.
4. Consult with your nearest dealer for proper installation or if common parts need to be used.
Seek assistance if modifications or drilling holes to your vessel is needed.
5. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign
particles or vibration. Areas of high temperature from the engine, direct sunlight, heater or hot
air should also be avoided.
6. Do not install the unit in a location where it will interfere with the vessel operation, or it will
injure the passengers if there is a sudden or emergency stop.
3. Head Unit Installation
12
2.96"
NO. PART DESCRIPTION
1 MAIN DEVICE
2 MOUNTING SURFACE
3 MOUNTING STUDS
4 JAM NUTS
5 MOUNTING BRACKET
6 SPRING WASHER
7 OUTER NUTS
Instructions:
1. Install jamb nuts (4) loosely on mounting
studs (3), so they will not touch mounting
brackets (5) when installed.
2. Slip mounting bracket (5) on and make
flush with mounting surface (2).
3. DO NOT TIGHTEN
4. Snug spring washer (6) and outer nuts (7)
against mounting plate (2).
5. DO NOT TIGHTEN
6. Position jamb nuts approximately 1/16"
from mounting bracket.
7. Tighten outer nuts completely.
Battery
Figure 1