Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
,
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged•DO NOTrun pressurewasher if
inlet screenis damagedor missing.
4.
Run water through garden hose for 30 seconds to flush
it of debris• Turn off water•
IMPORTANT:DO NOTsiphon standing water for the water
supply• Use ONLY cold water (less than IO0°F).
5.
Connect garden hose (not to exceed 50 feet in length) to
water inlet• Tighten by hand•
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage•
ThereMUSTbe at leastten feet of unrestricted gardenhose
between the pressure washerinletand anydevice,suchas a
vacuumbreaker o r checkvalve•
Damage to equipment r esultingfrom failureto follow this
instructionwill void warranty•
6. Turn ONthe water, press red button (B) on the gun and
squeezethe trigger to purge the pump system of air and
impurities•
WARHJHG
Risk of eye injury•
• _
JSpray can splash back or propel objects•
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles•
NEVER substitutesafetyglassesfor safetygoggles•
ChecklistBefore Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1.
Be sure to read Safety Rules and Operationsections
before using the pressure washer•
2.
Make sure handle is in place and secure•
3.
Checkthat oil has been added to proper level in engine
crankcase•
4.
Add proper fuel to fuel tank•
5.
Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose•
6.
Provide proper water supply (not to exceed IO0°F).
10
Publicidad
Tabla de contenido
