NuTone ZN110HL Guia De Instalacion página 5

Page 5
New Construction Installation
5
Connect Wires and Install Knockout Plate
• Run 120VAC electrical wiring to the installation location.
• Use proper UL-approved connectors to secure wiring to the Knockout Plate provided in Parts Bag.
• Connect wires as shown in wiring diagram.
• Do not use a dimmer switch to operate the light.
Fan
WHT
BLK
120 VAC
LINE IN
GRD
MULTI-FUNCTION
MANUAL-ON
SENSOR/CONTROL
BLACK
WHITE
ORANGE
MANUAL - ON
SENSOR / CONTROL
MASTER
MULTI-FUNCTION
WALL CONTROLS
(purchase separately)
Attach cable clamps to Knockout
1
Plate. Knockout Plate mounts to
outside of Housing and may be
oriented as desired.
Light
2
Connect wires
WALL SWITCHES
LIGHT
NIGHT
LIGHT
MASTER
RED GROUND
(green or bare)
BLUE
BROWN
SWITCH
BOX
LIGHT
NIGHT
LIGHT
120 VAC
LINE IN
WHT
BLK
RED
14/3
14/4
(IF ALL
WALL SWITCH
OPTIONS
ARE USED)
RED
BLU
BLK
WHT
GRD
LIGHT RECEPTACLE WIRES
RECEPTACLES
KNOCKOUT
PLATE
FAN RECEPTACLE
WIRES
ZN110HL Installation Guide
3
4
Screw from
Parts Bag
WHT
BLU
LIGHT
RED
NIGHT
LIGHT
SENSOR/
CONTROL
BLK
FAN
BLK
WHT
• MANUAL-ON switch is not required
to manually increase fan operation to
certified airflow rate (see page 10).
• MASTER and SENSOR/CONTROL
switches can be combined (see page
10).
• MASTER switch along with or
separate from SENSOR/CONTROL
switch may be located where they
are not easily accessed for everyday
usage; they may need to be labeled
and located where they can't be turned
on without being seen from fan to
comply with local and national codes.
• See OPERATION
section on page 12 for
details.
• MASTER switch
turns fan system on
and shuts it off for
fan cleaning and
maintenance purposes.
• SENSOR/CONTROL
switch turns humidity
control automatic
operation on/off.
• MANUAL-ON switch
directly increases fan
operation to certified
airflow rate.
• MASTER switch must
be on for humidity
control or MANUAL-ON
switch to change fan
operation to certified
airflow rate.