Publicidad
Insert the "T" section of rubber clip into the square
hole in the back of the chamber. Rotate and twist
the rubber clip so that the word is up and the angle
section faces inward.
5. Press and hold the side button for 2 seconds to
begin process. The LED light stays on.
6. The sanitizing process will take up to 6 minutes.
Note: It may take up to 30 seconds for bulb to
illuminate.
7. During the sanitizing process, unit automatically
shuts off when door is open.
8. Unit automatically shuts off when cycle is complete.
9. Press and hold the button for 2 seconds to end the
process.
10. Three quick blinks followed by a 3-second pause
indicates the batteries are low.
11. Any other services should be performed by an
authorized service representative.
CLEANING DIRECTIONS:
To clean inside unit:
1. Use a damp cloth to wipe down all internal surfaces
of unit. Use water only.
2. DO NOT Immerse in water.
4
Publicidad
