Brita Maxtra Water Filter System - Bosch Filtrino THD20 Serie Instrucciones De Uso

18
BRITA MAXTRA water
filter system
In models equipped with a water filter
system, only BRITA MAXTRA water
filter cartridges may be used.
BRITA MAXTRA cartridges can be
purchased from retailers or directly from
Bosch Customer Service. (See the back
pages of these instructions for contact
information).
The appliance can be used with or without
a filter cartridge.
Keep in mind that you will enjoy the bene-
fits of B RITA filtration only if a M AXTRA
filter cartridge is installed in the appliance.
Tea and coffee also have more aroma
when prepared with fresh, B RITA-filtered
water.
To use the machine without a filter, simply
remove the filter holder and the filter
cartridge and adjust the machine settings
accordingly.
Important: The Filter Yes/No setting
controls the filter replacement indicator.
Changing the filter setting
Turn the appliance off with the on/off
►
switch.
Press and hold the temp. set button.
►
Turn the appliance back on with the
►
on/off switch – the M icon flashes.
Press the start/stop button to select the
►
Filter Yes/No setting:
Yes = M lights up
or
No = M does not light up
Release the temp. set button – the set-
►
ting is now stored, and the most recently
selected temperature lights up.
Note: To change this setting at any time,
repeat the above procedure.
After setting the filter to "yes", the symbol
M will light up after a certain time during
operation. The B RITA M AXTRA filter
cartridge is exhausted and needs to be
changed.
Robert Bosch Hausgeräte GmbH
To install a new filter cartridge, proceed as
follows:
Preparing and installing the BRITA
MAXTRA filter cartridge
Remove the filter cartridge's protective
►
packaging.
Immerse the filter cartridge in cold tap
►
water and shake it lightly (for about five
seconds) to remove any air bubbles.
Take the filter holder out of the water tank
►
and firmly insert the cartridge into the
holder until you hear a click.
Hold the filter holder under the water tap
►
and fill it with fresh, cold water; let the
water run through the BRITA MAXTRA
filter cartridge.
Repeat this procedure two or three times.
►
Place the filter holder with the filter
►
cartridge back into its position in the
empty water tank and fill the tank with
cold tap water.
Hold down start/stop button for at least
►
2 seconds to delete M .
Note: To replace the cartridge, simply
pull on the strap attached to the top of the
cartridge. When installing a new cartridge,
follow the above steps for preparing and
inserting a cartridge.
U sed B RITA M AXTRA water filter
cartridges can be disposed of with
the regular household garbage. If you
have more questions, contact BRITA
Consumer Service at 0844 742 4800
(toll-free).
Important information
– Always store spare filter cartridges
sealed in the original packaging in a cool
and dry place.
– B RITA water filters are designed for use
only with municipally treated tap water
(note: this water is constantly control-
led and according to legal regulations
safe to drink) or with water from private
supplies which has been tested as safe
to drink. If an instruction is received from
the authorities that mains water must be
en