Introduction..................................................................... 2
Safety..............................................................................6
Assembly........................................................................ 8
Operation........................................................................ 8
Owner responsibility
WARNING: Processing of concrete and
stone by methods such as cutting, grinding
or drilling, especially during dry operation,
generates dust that comes from the material
being processed, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
California Proposition 65
Product description
Dust-laden air is sucked through the inlet valve at high
speed via the suction hose. The cyclone slows down the
air and separates coarse dust particles through
centrifugal force and gravity. The double filter system
then separates the air and finer particles. The dust
2
Contents
Introduction
WARNING
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects
or other reproductive harm.
Maintenance................................................................... 9
Troubleshooting............................................................ 13
Technical data.............................................................. 15
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, use water to
bind the dust, when feasible. If dry operation
is necessary, use an appropriate dust
extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
•
The products's safety instructions.
•
The products's range of applications and limitations.
•
How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
extractor is designed for filter cleaning by reverse air
pulse.
The separated dust accumulates in the cyclone until the
product is switched off, then it drops through the bottom
flap into the plastic bag. The filter cleaning process is
not completed before it is clear that the dust inside the
tank has fallen into the collection bag.
1105 - 001 - 11.07.2019