Technical Data; Recommended Wires - Husqvarna CS 2512 Manual De Instrucciones

Operator's Manual CS 2512

Technical data

Power on drive wheel (with PP 455): ____ 20 kW
Hydraulic oil flow: ___________________ 65l/min (17gal/min)
Max permitted hydraulic pressure ______ 230 bar (3400 psi)
Max recommended hydraulic
pressure when cutting: _______________ 130 bar (1900psi)
Maximal wire length in the magazine: ___ 12 m
Dimensions, handle folded in and
the guard folded down (L x W x H) ______ 1150x750x980 mm
Weight: ___________________________ 150 kg ( 330 lbs)
Wire speed gear 1 __________________ 20 m/s (66 ft/s)
Wire speed gear 2 __________________ 25 m/s (82 ft/s)
WARNING
Under no circumstances may
modifications be made to the machine
without written permission from
Husqvarna Construction Products Sweden
AB. Non approved modifications put you
and others at risk of serious or fatal
injuries. Husqvarna Construction Products
Sweden AB bears no responsibility for
operations that do not conform to these
instructions.

Recommended wires:

Husqvarna recommends that the following wires are used:
•
•
•
•
(2.4 m/wheel set)
•
•
For further information about different tools from
Husqvarna, contact your Husqvarna dealer.
Husqvarna C710C
Husqvarna C710C is a galvanised wire developed for
use when cutting concrete with a great deal of
reinforcement. The segments have a great number of
diamonds and a smaller diameter (9.5mm) which
means the wire cuts very efficiently. The smaller
diameter also means that C710C can be used to finish
difficult cuts.
Husqvarna C750C
Husqvarna C750C is an all round wire developed for
use when cutting reinforced concrete. The wire has
been designed for use with saws with an output power
between 10 and 25 kW.
Husqvarna C760C
This is the Husqvarna premium wire: long life, high
cutting rate and high power resistance characterize
this wire. Husqvarna C760C can be used to cut all
types of reinforced concrete, even when the work
places high demands on the wire, for example when
cutting bridges.
Husqvarna C790C
The segment strength on this wire makes Husqvarna
C790C the best choice when cutting soft materials
such as mortar, and lightly reinforced limestone
concrete.
Husqvarna C575J
Husqvarna C575J is a wire with galvanised 15 mm
segments.
Husqvarna C1200M
Husqvarna C1200M is a wire developed for use when
cutting steel. The wire has been designed for use in
extremely demanding situations. The use of the latest
sintering technique has given enormous advantages
with regard to cutting rates and life span. The wire can
be supplied with either joined or loose ends.
English - 15