Fitting Procedure - Panasonic TY-WK70PV50 Instrucciones De Montaje

Fitting procedure

1. Assembling the
wall-hanging bracket
Lay the base upper and lower
¿ ttings and the bracket
base left and right ¿ ttings
and as shown in the ¿ gure.
Fit the protrusions (tabs)
of the bracket base upper
and lower ¿ ttings
cutouts in the bracket base
left and right ¿ ttings
, and secure them using the
eight screws for assembling
the ¿ xture .
(Tightening torque: 1.2 to 1.5 N•m)
Note
• Please hold the bracket base
left and right ¿ ttings as you work
with the assembled wall hanging
bracket. Holding the base upper
and lower ¿ ttings might deform
this unit.
2. Checking the strength of
the installation location
The wall-hanging bracket weighs
approximately 2.5 kg (5.6 lbs).
Refer to the instruction manual
of the display, and check the
weight of the display unit
which will be ¿ tted into the
wall-hanging bracket.
Refer to the outline drawing
of the wall-hanging bracket
shown on the right, and check
the wall strength at the six
installation positions shown.
If the strength at any of these
positions is lacking, provide
suf¿ cient reinforcement.
Note
• There are seven pre-drilled mounting
holes at the top and another seven at
the bottom of the wall-hanging bracket.
Use the spare holes provided if
wood or some other material is used
for the wall and a suf¿ cient level of
mounting strength cannot be ensured
by anchoring the ¿ xture at the six
positions shown on the right.
However, bear in mind that, depending
on which materials the mounting
surface is made of, cracks may form
on the surface if the screws are used at
positions which are too close together.
Model nameplate
Bracket base
left fitting
Bracket base
into the
right fitting
and
50
(2.0)
Wall mounting holes (at 6 points)
Use the screws without fail to anchor the ¿ xture.
Base upper fitting
Base lower fitting
500 (19.7)
400 (15.8)
140 (5.6)
220 (8.7)
324 (12.8)
470 (18.5)
Cutout
Tab
Screws for
assembling
the fixture
Screws for
assembling
the fixture
Unit: mm (inches)
50
30 (1.2)
(2.0)
26.2 (1.1)
21