Threading The Wire - Husqvarna CS 2512 Manual De Instrucciones

Threading the wire

NOTICE! A used wire must always be run in the same
direction, as it was previously run in order to prevent
unnecessary wear.
The guard can easily be lifted off to facilitate fitting wire. Now
thread the wire as follows:
1 Make sure the magazine is in the min position.
2 Place the wire around the work piece, possibly through the
predrilled holes and back to the saw.
3 Thread the wire through the hole by the swivel wheel and
around a suitable number of wheel sets in the magazine.
4 Adjust the drive wheel unit according to the number of
wheel sets used in the magazine:
Loosen the arm by screwing out the knob anticlockwise.
Now turn the drive wheel unit so that the arm is aligned
with the markings on the saw. Lock the drive wheel unit by
turning back the knob.
Usually only one wheel set is used in the first stage of
cutting.
10 –
English
ASSEMBLY
5 Thread the wire around the drive wheel and out through
the hole by the second swivel wheel. The swivel wheel can
rotate and be locked in the required position by turning the
marked (A) knobs.
6 Before the joints on the wire are connected, the wire
should be twisted 1 to 2 turns per metre wire used. It is
important to twist the wire in the same direction as it is
spun. This is to give as even wear as possible on the wire's
diamond segments.
7 Lock the wire with a pin. If there are no end sleeves on the
wire, these must be spliced on to the wire. A special pair
of wire pliers must be used. If you are unsure about which
model you should use, contact your Husqvarna dealer.
8 When the wire is routed correctly it should run through the
machine as in the figure below:
a