Operation - Husqvarna FS 413 Manual Del Operador

Before Operation:
Use: This machine is used only for wet or dry sawing of
old and new concrete and asphalt.
WARNING!
DO NOT use for dry cutting in European Union (EU)
regions. Machine is not equipped with a dust port.
Tools: Use machine only with the following tools (H): Wa-
ter Cooled Diamond Blades. Reinforced Abrasive Blades
or Dry Cutting Diamond blades should NOT be used with-
in European Union (EU) regions because this machine, as
supplied, does not include a dust collector port.
Diameter: 00 mm (") – 00 mm (0").
Bore: .mm (.00").
WARNING!
DO NOT use carbide, wood saw, or circular saw
blades on this machine, else injury or death could oc-
cur.
Re-Locating the Blade Guard (C) - If Required:
Blade Guard (C) is factory installed on right hand side of
machine, but can be relocated to left side. This may allow
cutting closer to obstacles, if approaching them from the
opposite direction is not possible.
. Use mm Wrench (U) to remove Blade Guard Rear
Bolt (E) from Blade Guard (C).
. Push back collar to separate Water Hose Disconnect
(G). Male half remains with Blade Guard (C). Female
half remains with Water Tank (P) or Water Control Valve
(KK).
. Lift Blade Guard (C) upward, and off of Blade Guard
Mounting Spade (Y).
. Use mm Wrench (U) to remove four () screws that
attach Blade Guard Latch Plate (F). Re-attach the Blade
Guard Latch Plate (F) to the left hand side of Blade Guard
(C).
. Remove and relocate Shaft Guard (W) from left hand
side of machine to right hand side.
. Lower Blade Guard (C) onto Blade Guard Mounting
Spade (Y) on left hand side of machine.
. Re-Install Rear Bolt (E) in Blade Guard (C).
8. Re-Attach Water Hose Disconnect (G) from Blade
Guard (C) to Water Tank (P) or Water Valve (KK). Take
care that relocated hose will not contact muffler.
9. Relocate and realign Front Pointer (A) so Guide Wheel
(B) is on left side of machine.

OPERATION

Before operating machine, read and under-
stand this entire operation manual & engine
operation manual supplied with engine.
Be familiar with machine before operation!
WARNING!
Operator must wear
personal protective
equipment & cloth-
ing appropriate to the
work he is doing.
Personal protective
equipment, such as
hearing & eye protec-
tion, is mandatory.