Operation; To Turn On/Off; To Adjust The Temperature; Timer Setting - Furrion FF23SW15A-BL Manual De Instrucciones

Operation

NOTE: For your safety, this fireplace is
equipped with a proximity sensor device.
When objects are detected within six
inches, the fireplace will automatically
cut out and a red LED will flash. The
fireplace will not come back on without
being reset.
Remove the marketing sticker from
the front glass and the protective film
before use. Operation of the unit without
complete removal of the protective film
may increase the risk of fire and/or
product damage or injury.
Marketing Sticker

To Turn On/Off

Press on control panel or on the remote
control to turn on/off the fireplace.

To Adjust the Temperature

Press on the remote control to
increase the heat input, press
decrease the heat output.

Timer Setting

Press on control panel or on the
remote control will allow you to set the
timer of heating. You may set the time
from 30 minutes to 5 hours.

Interior Brightness Control

Press button on control panel or on
the remote control to select the desired
brightness levels.
● For FF23SC15A-BL, FF23SC15A-SS,
FF30SC15A-BL, FF30SC15A-SS,
FF34SC15A-BL, FF34SC15A-SS,
FF40SC15A-BL, FF40SC15A-SS,
FF48SC15A-BL, FF48SC15A-SS,
FF60SC15A-BL and FF60SC15A-SS
models, p
or on the remote control to select the
desired flame color of Orange, Blue or
Red. Press and hold for three seconds to
show the brightness levels of L4, L3, L2
and L1 in sequence and release to select
the desired.
● For FF23SW15A-BL, FF30SW15A-BL,
FF34SW15A-BL, FF40SW15A-BL,
FF48SW15A-BL, FF60SW15A-BL,
FF23SW15A-SS, FF30SW15A-SS,
FF34SW15A-SS, FF40SW15A-SS,
FF48SW15A-SS, FF60SW15A-SS
models, press
panel or on the remote control to
choose the brightness levels of L4,
L3, L2 or L1.

Thermostat Control

Press button on control panel or on the
remote control to adjust the temperature
to your individual requirements.
to
● Press once to activate the low heat
setting.
● Press twice to select the high heat
setting.
● Press the button a third time to turn
off the fireplace.
● When the fireplace is turning on,
press button for five seconds
to allow you to select the desired
temperature settings.
NOTE: When the fireplace is turning
on, press
toggle between
ress button on control panel
button on control
button for five seconds will
C and F.
o o
10