Before Operation; What's In The Box; Prepare Your Remote Control - Furrion FDUS50M7A Manual De Instrucciones

Before Operation

What's in the Box

Thanks for purchasing this Furrion 4K LED
TV. First, check the contents of your box with
the parts checklist below:
● TV
● Remote control
● AAA battery × 2
● Wall-mount screws × 4 (M6 x 20mm)
● Bottom mount stand × 2
● Bottom mount stand screws × 6
● Printing materials
Prepare your Remote
Control
BATTERY INSTALLATION
1. Open battery compartment cover.
2. Install two AAA batteries.
3. Close the cover of the battery
compartment.
NOTE: Use two "AAA" size batteries.
The batteries may last approximately one
year depending on how much the remote
control is used. For best performance, it is
recommended that batteries should be
14
replaced on a yearly basis, or when the
remote operation becomes erratic. Do not mix
old and new batteries or different types.
BATTERY PRECAUTIONS
These precautions should be followed when
using batteries in this device:
● Use only the size and type of batteries
specified.
● Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
● Do not mix different types of batteries
together (e.g. Alkaline and Carbon-zinc) or
old batteries with fresh ones.
● If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
● Do not try to recharge batteries not
intended to be recharged; they can
overheat and rupture. (Follow battery
manufacturer's directions.)
● Please use caution when inserting
batteries to avoid battery damage. If the
spring terminal in the remote control
remains in contact with a side of a
damaged battery it can cause a short
circuit. Never use damaged batteries
as they can become very hot and are
dangerous.