Sears Craftsman 917.377050 Manual De Uso página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE OIL
Drain oil (with engine warm) and replace with
clean engine oil, (See "ENGINE"
in the
Maintenance
section of this manual),
CYLINDER
* Remove spark plug.
,, Pour one ounce (29 ml) of oil through spark
plug hole into cylinder.
° Pull starter handle slowly a few times to
distribute oil,
,, Replace with new spark plug.
OTHER
* Do not store gasoline from one season to
another,
- Replace your gasoline can if your can
starts to rust. Rust and!or dirt in your
TROUBLESHOOTING
CHART
gasoline will cause problems,
• If possible, store your unit indoors and
cover it to give protection from dust and dirt.
, Cover your unit with a suitable protective
cover that does not retain moisture+ Do
not use plastic+ Plastic cannot breathe
which allows condensation
to form and will
cause your unit to rust,
IMPORTANT:
Never cover mower while
engine
and exhaust areas are still warm,
,&CAUTION:
Never store the lawn
mower with gasoline
in the tank inside
a
building
where
fumes
may reach an open
flame or spark.
Allow the engine
to cool
before
storing
in any enclosure,
Does not start
Loss of power
I+
Dirty air filter.
2+
Out of fuel
3.
Stale fuel.
4+ Water in fuel.
.
6+
7,
84
Spark plug wire is
disconnected.
Bad spark plug.
1.
Clean/replace
air filter+
2,+ Fill fuel tank.
3.
Drain tank and refill with
fresh clean fuel,
!4,
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
[5.
Connect wire to plug,,
6+
Replace spark ptug,
Loose blade or broken blade
adapter,
Control bar in released
position.
Control bar defective,
g_
1,
Rear of lawn mower housing
or cutting blade dragging
7,
Tighten blade bolt or
replace blade adapter+
8+ Depress control bar to
handle.
9+
Replace control bar.
J,
i
,
t
t,
1.
Set to "Higher Cut"
position.
in heavy grass,
2+ Cutting too much gras&
3+
Dirty air filter,
4.
Buildup of grass, leaves,
and trash under mower.
5.
Too much oil in engine.
6+ Walking speed too fast.
2_ Set to "Higher Cut"
position,
3+
Clean/replace
air filter.
4,
Clean underside
of mower
housing.
5o
Check oil level.
6+
Cut at slower walking
speed,
17

Publicidad

Tabla de contenido
loading

Tabla de contenido