Laminating; Removing A Jammed Laminating Pouch - Pembrook OL 350-L-17 Manual Del Usuario

Operation

Laminating

1. Move the ON / OFF switch
The ready indicator will turn from black to red within the next
1 ½–2 minutes.
2. Once the ready indicator
sides of the laminating pouch
Make sure that the document is flush with and aligned as close as possible
to the sealed edge of the laminating pouch.
3. Insert the laminating pouch so that it is centered and with the closed-edge
first into the laminating pouch infeed slot
The heating rollers will automatically pull the laminating pouch in and move
it to the laminating pouch output slot
Don't use force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has
− Repeat the process if the laminating pouch has not
5. Move the ON / OFF switch to "OFF" ( ) to switch the laminator off.

Removing a jammed laminating pouch

The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, proceed as
follows:
1. Move the ABS switch
hold it down (see fig. B).
2. Pull the laminating pouch
It is recommended you pull the laminating pouch out in the
direction of its larger end.
You can place the document in a new laminating pouch and laminate it again.
14
to "ON" ( ) (see fig. B).
3
1 is red, place the document between the two
cooled off.
adequately adhered to the document.
towards the laminating pouch infeed slot
4
6
6
.
2 on the back of the laminator.
5
on the front of the laminator.
out of the laminator.
and
2