TECshow DMX PINSPOT LED BAR Manual De Usuario página 9

Functions of the indicator and Dip Switch
1. DMX signal indicator (green led).
2. Power indicator (red led).
3. Dip Switch 1-9: DMX address setting.
4. Dip Switch 10: Full light of 6 LED lights (This
function prior to DMX control).
6. OPERATING INSTRUCTIONS
• Before plugging your device in, be sure the
source voltage in your area matches the re-
quired voltage for your lighting before attempt-
ing operation.
• Do not switch the device on and off in short
time intervals.
• Always unplug the device when it is not used for
a longer time or start servicing.
• In the event of serious operating problems,
stop using the device and contact your dealer
immediately.
• Important: Never look directly into the light
source! Don't use the effect in the presence of
persons suffering from epilepsy.
1. When power on, if the device works normal, the
power indicator lights up;
2. Connect the DMX 512 controller cable to the
input socket (J of figure 1) of the device.
Make sure the signal cable polarity is correct.
When DMX socket receives effective DMX
signals, DMX signal indicator of device
flashes and enter DMX control automatically;
3. If desired, connect another device: Plug one
end of another signal cable in to the output
socket (K of figure 1) on the back of the first
device; plug the other end of the signal cable
to the input socket (J of figure 1) on the back
of the second device. Follow the same proce-
dure to link more devices, if desired; whole
link is daisy chain.
4. Down. Refer to DMX channel chart in Figure 2
make related settings. Now start operating
DMX Pinspot LED Bar with DMX console.
• When DIP10 is ON, all 6 LED lights light up.
DIP10 is prior to DMX control.
English version
P. 9
| Tecshow DMX Pinspot LED Bar