Presentation - Husqvarna DM 230 Manual De Instrucciones

DM 230
It is our wish that you will be satisfied with your product
and that it will be your companion for a long time. Think of
this operator ' s manual as a valuable document. By
following its ' content (using, service, maintenance etc) the
life span and the second-hand value of the machine can
be extended. If you ever lend or sell this machine, make
sure that the borrower or buyer gets the operator ' s
manual, so they will also know how to properly maintain
and use it.
A purchase of one of our products gives you access to
professional help with repairs and services. If the retailer
who sells your machine is not one of our authorised
dealers, ask him for the address of your nearest service
workshop.
Husqvarna Construction Products has a policy of
continuous product development. Husqvarna reserves
the right to modify the design and appearance of products
without prior notice and without further obligation
introduce design modifications.
• The DM 230 is an electric handheld drill, intended for
drilling concrete, brick and various stone materials.
• The drilling machine has a modular design and is
easy to assemble.
• The machine is equipped with spirit levels to facilitate
drilling and a swivel handle with an integrated adapter
for support pins to make the work more comfortable.
• DM 230 has three speed ranges for drill bit sizes up to
150 mm.
• The machine has a water cooled gearbox with a pipe
that runs through the spindle.
• DM 230 can also be connected to a vacuum cleaner
with the help of an adapter, used for dry drilling, which
is attached to the spindle.
• The drilling machine is equipped with Softstart
TM
Smartstart , Elgard
4 – English

PRESENTATION

TM
and speed control.
Softstart™
TM
Softstart
easier to start the drill. Maximum speed is reached in
about three seconds after the power switch is pressed in.
Smartstart
If the Smartstart
power switch is pressed in, the speed is reduced by 50%.
In Smartstart
the button is pressed in again. These functions are of
great use for creating a pilot hole for drilling.
Elgard™
TM
Elgard is an electronic overload protection.
If the motor is overloaded, the overload protection pulses
the motor. Reduce the load and the motor returns to its
normal speed. The overload protection disconnects the
power, if the machine is subjected to heavy loads or if the
drill bit jams. The machine is reset by first releasing the
power switch and then pressing it in again. If the drill bit
jams, the mechanical slip clutch protects the gearbox
before the overload protection disconnects the power.
Speed control
Speed control always gives maximum output power from
the machine. The speed control function provides the
machine with a limited idling speed.
Ergonomics
The soft rear section on the DM 230 has a large contact
area so that the machine sits better against the body. The
rounded handle makes the machine comfortable to hold
while drilling. The protective loop forms a practical carry
handle when transporting.
TM
,
is an electronic power limitation, making it
TM
TM
button is pressed in directly after the
TM
mode the machine has less power until