en
Cleaning
4. Only use the pusher provided to push
the food further. The sorbet produced
will be collected in the container.
Reversing function
The reversing function is designed to
release food that has got stuck by briefly
running the worm gear in reverse.
■ Move the switch to O and wait for the
appliance to come to a stop.
■ Move the switch to { and keep it
pressed.
■ After approx. 3-5 seconds, release the
switch and wait for the appliance to
come to a stop.
■ Move the switch to ON and continue
with the juicing.
Note: If food that has got stuck is not
released by briefly putting the appliance into
reverse, switch the appliance off, unplug it
and clean it. X "Cleaning" see page 16
Warning!
The reversing function must be used for
several seconds or it will no longer be pos-
sible to switch on the appliance.
After using the appliance
■ Empty both containers and then place
them under the apertures for juice and
fruit pulp again.
■ Close the sealing cap and slide the
adjusting lever for the fruit pulp all the
way to the right.
■ Pour a little water (approx. 150 ml) into
the feed chute and move the switch
to ON.
■ After a short time, open the sealing cap
and slide the adjusting lever for fruit pulp
all the way to the left.
■ Let the appliance slow down and stop
completely before switching it off.
■ Move the switch to O and wait for the
appliance to come to a stop.
■ Disconnect the mains plug.
■ Clean all parts immediately after use.
16
Cleaning
The appliance and the individual parts used
must be thoroughly cleaned after each use.
W Risk of electric shock!
– Unplug the appliance before cleaning it.
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
– Do not steam-clean the appliance.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not clean the individual parts in the
dishwasher.
Notes:
– When processing food such as carrots,
plastic parts may become discoloured.
This can be removed with a few drops of
cooking oil.
– Completely open the seal for fruit pulp.
X "Adjusting lever / seal for fruit pulp"
see page 14
In Fig. H you will find a summary of how to
clean the individual parts.
Dismantling the appliance
■ Rotate the lid to the marking (,) and
remove.
■ Remove the assembled juice drum.
■ Then dismantle the juicer screw, strainer
or sorbet insert piece and the rotating
brush one by one.
Note: If the individual parts in the juice
drum are jammed (e.g. due to remnants of
fruit), proceed as follows.
X Image sequence I
1. Turn the juice drum over, putting a cloth
underneath.
2. On the underside carefully press on the
drive shaft of the juicer screw until it
releases.
3. Remove all individual parts.