Transport And Storage - Husqvarna DM 220 Manual De Instrucciones

The system senses the machine's deviation from the
horizontal plane.
If the back of the machine is tilted downwards, the central
green LED goes out and the front red LED lights up. If the
back end of the machine is tilted up, the back red LED lights
up.
Vertical position
The central green LED lights up when the machine is aligned
vertically.
The system senses deviations in two planes.
If the back of the machine is tilted downwards, the central
green LED goes out and the front red LED lights up. If the
back end of the machine is tilted up, the back red LED lights
up.
If the back end of the machine is tilted to the right, the central
green LED goes out and the left red LED lights up. If the back
end of the machine is tilted to the left, the right hand red LED
lights up.
Customised angle setting
The Level guiding system in the machine can be configured
to set a customised drill angle.
12 –
English
OPERATING
• Hold the machine at the required angle and press the
Reset button.
• Zero the angle setting by keeping the Reset button
pressed in for about 3 seconds.
The setting is also zeroed if the machine is disconnected
from the mains supply for a long time.
Deactivate the system
The system can be deactivated temporarily by pressing the
ON/OFF button. Deactivation is set to zero if the ON/OFF
button is pressed again or when the power is disconnected.
The system is deactivated for the time being by pressing the
ON/OFF button for approx. 3 seconds. Press the ON/OFF
button to activate the system again.

Transport and storage

• Do not store or transport the drilling machine with the drill
bit fitted in order to protect your drilling machine and drill
bits from damage.
• Secure the equipment during transportation in order to
avoid transport damage and accidents.
• Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
• Store the machine and its equipment in a dry and frost
proof place.