Powerboost Function; Maintenance; Maintenance Schedule - Husqvarna LB 548i Manual De Usuario

To use the drive on the wheels (LC
551iV)
• Pull the drive bail in the direction of the handlebar to
start the drive. (Fig. 57)
• Push + and - on the control panel to set the drive
speed in 4 steps. (Fig. 58)
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To use the SavE function
The product has a battery saving function (SavE) that
gives longer operation time.
1. Push the SavE button (A) to start the function. The
SavE symbol (B) on the display comes on.
2. Push the SavE button again to stop the function. The
SavE symbol (B) on the display goes out. (Fig. 59)
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically again when the
ground conditions let it.

PowerBoost function

When the product cuts long or wet grass, the motor
automatically increases rpm. To save battery time, the
motor goes back to standard mode automatically when
the PowerBoost function is not necessary.
To stop the product
The product stops automatically if you do not operate it
for 3 minutes.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Do a general inspection
Clean the transmission covers. Make sure that the motor does not have grass on
it
Do a check of the start inhibitor *
Make sure that the safety devices on the product are not defective *
22
1. Release the motor brake handle to stop the motor.
(Fig. 21)
2. Push the ON/OFF button on the control panel. All
LED lights and symbols on the display go out. (Fig.
60)
3. Remove the safety key from the safety lock and put
it in the safety key holder.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
To cut grass without a grass catcher or
mulch plug attached (LC 551iV)
1. Lift up the rear cover and remove the grass catcher.
2. If a mulch plug and a mulch blade are attached,
remove them.
3. Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.

Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
instructions for operation on page 15 .
Safety
Each use Monthly
X
X
X
X
1336 - 003 - 17.12.2019
Each
season