Maintenance Instructions; Moving And Storage Instructions; Troubleshooting - Schumacher PBI1812 Manual De Usuario

7.2 When using the other features of the booster, always observe the following steps:
1. Ensure the battery clips are securely clipped on the clamp holders.
2. Charge the booster as soon as possible after using the feature.
7.3 Powering a 12V DC Device:
The booster is a power source for all 12V DC accessories that are equipped with a 12V
accessory plug. Use it for power outages and fishing or camping trips.
Make sure the device to be powered is OFF before inserting the 12V DC accessory plug
into the 12V DC accessory outlet.
1. Open the protective cover of the DC power outlet on the front of the booster.
2. Plug the device into the outlet, and turn the device on (if required).
3. If the device draws more than 15A or has a short circuit, the internal circuit breaker
of the booster will trip and disconnect the power to the device. Disconnect the device
and the breaker will automatically reset.
IMPORTANT
operation of a 12V device may result in excessive battery drain. Recharge immediately
after unplugging the device.
8.

MAINTENANCE INSTRUCTIONS

8.1 Unplug the charger from the booster before attempting any maintenance or cleaning.
8.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clamps,
cords and the booster case. Do not use cleaning fluids.
8.3
Ensure that all of the booster components are in place and in good working condition.
8.4
All other servicing should be performed by qualified service personnel.
9.

MOVING AND STORAGE INSTRUCTIONS

9.1 Store the booster in an upright position, inside, in a cool, dry place.
9.2 Always make sure the booster is fully charged before storing. When not using it for long
periods of time, recharge the booster every 30 days.
IMPORTANT
damage could occur if the internal battery should unexpectedly leak acid.
10.

TROUBLESHOOTING

PROBLEM
The booster won't jump start
my car.
The DC power outlet is wired directly to the internal battery. Extended
Do not use and/or store the booster in or on any area or surface where
POSSIBLE CAUSE
Clips are not making a good
connection to the battery.
The booster battery is not
charged.
The vehicle's battery is
defective.
35
• •
REASON/SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Check the battery charge
status by pressing the button
on the front of the booster.
See LED Indicators section of
this manual.
Have the battery checked.