Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Maintenance
Factory
reset
the
system
To troubleshoot
problems, reset the System menu and ADAPTiQ ® to the
factory settings.
1.
Press
on the remote control.
2.
Press y until 16 FACTORY RESET appears on the display.
3.
Press 5.
The system resets.
4.
Run the ADAPTiQ audio calibration (see page 18).
Reset a source
button
on the
remote
control
If you are experiencing
problems with a source button on the remote control, reset
the source button to the factory settings.
Note: After performing this procedure, your source button is in CEC mode.
1.
On the remote control, press and hold the appropriate source button until all
six source buttons glow, then release.
Only the appropriate
source button glows.
2.
On the number keypad, enter 0140.
Service
connectors
on the Acoustimass
module
The Service and Data connectors
are for service use only. Do not insert any cables
into these connectors.
30 - English
Publicidad
Capítulos
Tabla de contenido
