How To Operate; Helpful Tips - Nostalgia ISM1000 Instrucciones Y Recetas

HOW TO OPERATE

1. Fill a standard ice cube tray with water and place in
freezer until frozen. Remove ice from tray(s).
2. Place the ELECTRIC SNOW CONE MAKER on a stable, waterproof
surface near an electrical outlet before starting.
3. Always make sure that the cord is away from a water source.
4. With Shaver Bowl placed on top of Base, place frozen ice cubes in Shaver Bowl. DO NOT FILL
PAST MAX FILL LINE (holds approximately 8 medium-sized ice cubes).
BE CAREFUL when placing ice cubes in Shaver Bowl as the blade in the Shaver Bowl is
very sharp.
5. Place a cone under the Shaver Bowl to catch the shaved ice.
6. Place the Motor Cabinet on top of the Shaver Bowl and hold in place. When filled with
ice, the Motor Cabinet will rest a few inches above the bottom of the Shaver Bowl.
7. Plug unit into an electrical outlet. To begin shaving, hold the Motor Cabinet steady with one
hand and press down on the Power Button.
NOTE: For your safety this unit is equipped with a built-in safety switch.
Ice must be in the Shaver Bowl for the unit to work. When the ice level
gets too low, the safety switch will engage and stop the motor.
8. Press the Power Button continuously until majority of ice is shaved,
or until the Motor Cabinet sits flush on the bottom of the Ice Bowl.
To stop shaving ice, release pressure on the Power Button.
9. Some ice may remain in the Shaver Bowl. Discard this ice before adding a new ice cube.
10. Repeat the process until you have the desired amount of shaved ice.
11. After each 1 minute of continuous use, wait 10 minutes
before using again to allow motor to cool.
12. Unplug unit from outlet when finished.

HELPFUL TIPS

USING TRADITIONAL ICE CUBES
• Place 8 medium-sized ice cubes in an even layer in Shaver
Bowl to yield approximately 2 cups of shaved ice.
• Do not overfill Shaver Bowl with ice (see max fill line in shaver bowl).
SAFETY SWITCH
• For your safety this unit is equipped with a built-in safety switch. Ice
must be in the Shaver Bowl for the unit to work. When the ice level gets
too low, the safety switch will engage and stop the motor.
6