Indicator Lights; Water Use - Maytag NEPTUNE MAH-1 Guía De Uso Y Cuidado

O I
PERATING
Step 6
S S
ELECT THE IGNAL (S
Press the "+" or "-" signal pad to increase or decrease the end of cycle signal volume.
Step 7
S Y M
TART OUR AYTAG
• Close the door.
• Add detergent and additives to the dispenser (See page 6).
• Push the start/pause pad.
• When the washer is started after a pause, there will be a 30-second
delay before continuing the cycle.
Pressing off cancels the cycle and stops the washer,
NOTE: When the cycle is complete, the door locked light will go out.The
door will open easily. Do not attempt to open the washer door when the
door locked light is illuminated.To add a forgotten item, see page 2.
E T
STIMATED IME
After pressing start/pause, this display will show the estimated time
remaining in the cycle.The estimated time remaining may fluctuate to better
indicate the wash time left in the cycle.
I L
NDICATOR IGHTS
Door locked – Lights whenever the door of the washer is locked.The door
can be unlocked by pressing the start/pause pad to stop the washer.
Pad Indicator Lights – The indicator lights above the pads will illuminate
when the pad is selected.
W U
ATER SE
The amount of water used will vary with each load.The Maytag
clothes washer uses an adaptive fill valve to provide the appropriate amount of
water for efficient cleaning performance and conservation of water and energy.
Fill time will vary depending on water pressure.
NSTRUCTIONS
M )
ELECT ODELS
N ® W
EPTUNE
D
ISPLAY
ASHER
® Neptune ®
5