For Tool With Conventional Planer Blades; Removing Or Installing Planer Blades - Makita M1902 Manual De Instrucciones

To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
CAUTION:
Do not pull the switch trigger hard
without depressing the lock-off button. This can
cause switch breakage.
Foot
Country specific
► 1. Planer blade 2. Rear base 3. Foot
After a cutting operation, raise the back side of the tool
so that the foot comes out of the rear base. This pre-
vents the planer blades to be damaged.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Removing or installing planer
blades
CAUTION:
Tighten the blade installation bolts
carefully when attaching the planer blades to
the tool. A loose installation bolt can be dangerous.
Always check to see they are tightened securely.
CAUTION:
Handle the planer blades very
carefully. Use gloves or rags to protect your fin-
gers or hands when removing or installing the
blades.
CAUTION:
Use only the Makita wrench
provided to remove or install the planer blades.
Failure to do so may result in overtightening or insuf-
ficient tightening of the installation bolts. This could
cause an injury.
For tool with conventional planer
blades
To remove the planer blades on the drum, unscrew the
installation bolts with the hex wrench. The drum cover
comes off together with the blades.
1
1
2 ► 1. Hex wrench 2. Bolts
3
► 1. Bolts 2. Drum 3. Planer blade 4. Drum cover
5. Adjusting plate 6. Groove
To install the planer blades, do the following procedure.
1.
Clean out all chips or foreign matter adhering to
the drum and planer blades.
2. Choose planer blades of the same dimensions
and weight. Otherwise drum oscillation/vibration will
result, causing poor planing action and, eventually, tool
breakdown.
3. Use the blade gauge to set the planer blades cor-
rectly. Put the planer blade on the blade gauge. Apply
the cutting edge of the blade on the inside flank of the
blade gauge.
5 ENGLISH
2
3
4
5
2
1
6