Delta UniSAW 36-L336 Manual De Instrucciones página 16

The blade tilting mechanism allows the blade to be tilted
up to 45° to the left.
To tilt the saw blade, loosen the lock knob (DD) Fig. 23
counterclockwise and turn handwheel (CC). A pointer (EE)
Fig. 24 indicates the angle of tilt on the scale, marked in
1/2-degree increments.
To lock the saw blade at your desired angle, tighten the
lock knob (DD).
DD
THROAT PLATE ADJUSTMENT
The throat plate (FF) Fig. 25 needs to be level to the saw
table. If the throat plate is not level with the saw table,
adjust the plate using four set screws (GG). Lower or raise
set screws as needed to align throat plate level to the saw
table.
RIVING KNIFE OPERATION AND
ADJUSTMENT
CC
POSITIONING THE RIVING KNIFE
FIG. 23
The riving knife (J) Fig. 26 is a flat plate that fits into the
cut made by the saw blade and effectively fights kickback
by lessening the tendency of the blade to bind in the cut.
(NOTE: Safety devices removed for clarity in Fig. 26.
J
Be sure to always use safety devices when possible.)
The riving knife (J) Fig. 27 and Fig. 28 can be used in
through cuts (where the workpiece is completely cut in
two) and non-through cuts. The riving knife can be moved
to the high position (Fig. 27) for through cuts and to the
low position (Fig. 28) for non-through cuts.
EE
NOTE: When adjusting the riving knife up or down, be
sure to pull in a radial motion, as shown in Fig. 28A.
FIG. 24
To adjust the riving knife position, there are two methods:
FRONT-RELEASE (PRIMARY METHOD)
FIG. 26
1. Pull front riving knife release handle (II) Fig. 29 in front
J
J
FF
GG
FIG. 28
FIG. 27
FIG. 25
FIG. 28A
16