Adjusting The Volume; Mode Selection; Manual Tuning - Ryobi P741 Manual Del Operador

TURNING THE RADIO ON/OFF
See Figure 4, page 9.
Press the ON/OFF button to turn the radio on or off.
NOTE: When the radio is off, the time will be shown on the
display even if the 18V battery is removed after the AAA
batteries have been installed.

ADJUSTING THE VOLUME

See Figure 4, page 9.
When the radio is turned ON, it will return to the last volume
setting used.
NOTE: If the 18V battery is removed from the radio or has
no charge, the radio will return to the default volume setting.
To increase the volume: push the VOLUME UP button.
To decrease the volume: push the VOLUME DOWN button.
NOTE: To change volume quickly, hold the VOLUME UP or
VOLUME DOWN button.

MODE SELECTION

See Figure 4, page 9.
To switch modes, press the MODE button. The selected mode
will be shown in the digital display. There are three modes:
 FM mode
 AM mode
 AUX mode
NOTE: When turned on, the radio will return to the last
mode that was used unless the 18V battery is removed or
has no charge.

MANUAL TUNING

See Figure 4, page 9.
The TUNE/SEEK buttons are used to manually tune to the
desired radio frequency. The selected frequency is displayed
on the digital display.
To use tune feature:
 Press the TUNE/SEEK DOWN button and quickly release
to tune to the next lowest frequency step.
 Press the TUNE/SEEK UP button and quickly release to
tune to the next highest frequency step.
To use seek feature:
 Press and hold TUNE/SEEK DOWN button for one
second to tune to the next lowest frequency with clear
reception.
 Press and hold TUNE/SEEK UP button for one second
to tune to the next highest frequency with clear reception.
To use the antenna:
 Raise or lower radio antenna until radio channel can be
heard clearly.
OPERATION
STORING A PRESET IN MEMORY
See Figure 4, page 9.
The memory feature saves up to 20 frequencies as presets
in the radio's memory. You can save 10 frequencies in FM
mode and 10 in AM mode.
To store a frequency in memory:
 Tune to the frequency you want to save.
 Press and hold the PRESET button. A memory location
number will blink on and off.
 Press the TUNE/SEEK UP or TUNE/SEEK DOWN button
to select a memory location.
 Press the PRESET button to store the frequency in the
selected memory location.
To recall a preset frequency:
 Press the PRESET button and quickly release to cycle
through stored frequencies.
SETTING THE CLOCK
See Figure 5, page 10.
Press the CLOCK button to view the time in the digital
display. To return to the frequency view, press the CLOCK
button again.
NOTE: In AUX mode, the time is always displayed.
To set the clock:
 Press the CLOCK button until the time is displayed on
the digital display.
 Press and hold the CLOCK button. The number
representing the hours will blink on and off.
 Press the VOLUME UP or VOLUME DOWN button to
set the hour.
NOTE: To set the clock to an hour between noon and
midnight, press the VOLUME UP or VOLUME DOWN
button until "PM" appears in the display.
 Press the CLOCK button. The number representing the
minutes will blink on and off.
 Press the VOLUME UP or VOLUME DOWN button to
set the minutes.
 Press the CLOCK button. The clock is now set.
NOTE: If AAA batteries are removed or lose charge for more
than 15 seconds, clock settings will be lost. Settings are not
affected by the removal of the 18 V battery.
7 — English