Unpacking; Components And Parts List - Delta 36-5000 T2 Manual De Instrucciones

• The machine is heavy, two people are required to unpack
and lift.
• Use a safety strap to avoid tip over when lifting machine.
• Prior to tool assembly and use, read this manual thoroughly
to familiarize yourself with proper assembly, maintenance
and safety procedures.
Check shipping carton and machine for damage before
unpacking. Carefully remove components in top foam layer.
Remove the top layer of foam then remove all components
in the bottom layer of foam. Lay out all parts on a piece of
cardboard or other clean, flat surface. Two or more people
are needed to lift the saw out of the carton. Always check for
and remove protective shipping materials around motors and
moving parts. Do not discard shipping carton and packing
materials until you have carefully inspected the contents,
assembled the machine and are satisfied that it operates
correctly.
COMPONENT
PARTS LIST
DESCRIPTION (QTY)
1.
Table Saw with attached
Carbide Blade, and Closed
End Wrench (1)
2.
Extension Wing
3.
Switch Box (attached to
saw) (1)
4.
Tubular Stand (2)
5.
Fixed Wheels (2)
6.
Adjustable Feet (2)
7.
Pivoting Pedal and Caster
(attached to saw) (1)
8.
Handwheel Handles (2)
(attached to saw)
9.
Lock Knobs (2)
10.
Miter Gauge (1)
11.
Rip Fence Handle (1)
12.
Extension Wing (2) with
36-5000 and 5100 (1)
with 36-5052 and 36-5152
13.
Rip Fence (1)
14.
Throat Plate (1)
15.
Blade Guard and Anti-
Kickback Pawls
16.
Blade (1)
17.
Push Stick (1)

UNPACKING

These contents in
separate carton
18. Rear Rail
19. Fence Guide
20. Front Fence Rail
15
16
1
2
14
10
3
4
5
9
Compare package contents to Component Parts List and
Hardware Package List prior to assembly to make sure all items
are present. Carefully inspect parts to make sure no damage
occurred during shipping. If any parts are missing, damaged
or preassembled, do not assemble. Instead, call DELTA
Customer Care at 1-800-223-7278 for assistance.
After assembly remove any protective materials and coatings
from all of the parts and the table saw. The protective coatings
can be removed by spraying WD-40
them off with a soft cloth. This may need to be redone
several times before all of the protective coatings are removed
completely.
After cleaning, apply a good quality paste wax to any
unpainted cast iron surfaces. Make sure to buff out the wax
before assembly.
These contents in separate carton for
36-5052 and 36-5152 only
21. Wood Table Extension
22. Legs
13
12
8
17
9
7
6
®
on them and wiping
®
21
11
22