General Safety Rules; Range Of Use - Surtek TRHP2 Manual De Usuario Y Garantía

GENERAL SAFETY RULES

WARNINGS:
- The truck shall be used, serviced and repaired
according to the manufacturer's requirements.
- The truck shall not be modified or have attach-
ments fitted without ensuring that the truck is
still safe.
- When the cargo weight exceeds 2500kg, we
recommed that two persons operate the truck
for labor-saving.
1. Read the operation instruction carefully be-
fore you operate the hand pallet truck and learn
about all the features of your product.
2. If you want to let the truck down by control-
ling the hand knob, we recomend that you lift
the hand knob a little at first, and then let the
truck down slowly. It is forbidden to pull the
handle knob with great force. Rapid dropping
could cause damages to both the hand pallet
truck and cargo.
3. Don't rock the hand grip at a high speed and
in a high frequency.
4. Don't load the cargo at a high speed.
5. Do not overload the forks. Overloading could
keep the hand pallet truck from working nor-
mally.
6. The gravity center of cargo should be in the
middle of truck forks. The offset of cargo could
make hand pallet truck out of balance.
7. Don't load loose or unstable goods.
8. Don't put the goods on the truck fork for a
long time.
9. When the truck does not work, make sure
that the truck forks are on the lowest position
and the power should be cut off.
10. It is forbidden to load people and let them
stand on the forks to slide. Don't put any part of
body below the cargo.
11. Do not operate the pallet truck if the cargo
is not in the right position.
12. The truck shall be used, serviced and re-
paired according to the manufacturer's require-
ments and shall not be modified or have attach-
ments fitted without ensuring that the truck is
still safe.
13. Do not use the hand pallet truck at an insuf-
ficiently illuminated place.
14. Do not park the hand pallet truck by turning
the hand grip to the right.
15. Do not use the hand pallet truck as a jack.
16. The extremity of fork arms shall not be used
as a lever to lift a load.
17. It is forbidden to use the truck at places
where a risk of unintentional movement exists.
18. It is forbidden to contact the truck with
E N G L I S H •
goods or cargo directly.
19. Do not use the hand pallet truck in a poten-
tially explosive atmosphere.
20. During the operation of the hand pallet
truck, the operator should pay more attention
to the feet and any body part so as to avoid the
risk of being crushed.
21. The truck shall be used, serviced and repaired
according to the manufacturer's requirements.

RANGE OF USE

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
Hand pallet truck is a low lift transportation tool
which is limited to move palletized cargo. This
kind of truck possesses the feature of stable lift-
ing, easy operation, safety and reliability etc.
NOTE: The working place must be non-slip, hard
and flat ground without holes or obstacles.
IMPORTANT: The ambient lighting is 50 lux
at least.
ASSEMBLY INSTRUCTIONS
See figure 1. Pull out the pin roll (1). Insert the
hand grip (3) to place (A). Couple the hand grip
(3) and pump body (5) with pin roll (1).
Then get the spring pin (2) through pin roll (1)
and fix it. Put the chain 4 of hand grip get across
the middle hole of pin roll (1).
Fig.1
Take screw nut which is at the end of chain (4)
and hitch the groove of lever board (6). See fig-
ure 2 and 4.
See figure 3. Turn the hand grip to the level po-
sition, pull out pin and save pin (7) with care for
next use.
Fig.3
U s er 's M an u al
Fig.2
Fig.4
6