Inserting The Batteries; Inserting The Memory Card - Velleman CAMCOLVC26N Manual Del Usuario

Operating buttons, connections and batteries are located inside the camera.
To open the camera, undo the two lateral locking brackets as shown in
fig. 1. To lock the camera again, engage the metal hoops of the locking
brackets into the mount and press down the plastic tab as in fig. 2.
A fixing for a padlock is provided between the two locking brackets, allowing
the camera to be securely locked.

6.2 Inserting the Batteries

Open the camera as described above. Open the protective cover of the
battery compartment by pulling the clamping closure at the top slightly
inwards before lifting the cover.
Insert eight fully charged batteries according to the correct polarity.
Close the battery compartment again with the protective cover.
Note
An alarm is sounded if battery charge is too low.
WARNING
Do not puncture batteries or throw them in fire as
they may explode. Do not attempt to recharge non-
rechargeable batteries (alkaline). Dispose of batteries
in accordance with local regulations. Keep batteries
away from children.

6.3 Inserting the Memory Card

Before switching on the camera, insert
an SD/SDHC memory card in the card
slot in order to save photos and
videos.
Switch off the camera and open as
described above.
Ensure that the lateral protection on
the card has not been activated. Insert
the card as shown. Push the memory
card into the slot until it clicks into
place.
To remove the card, push it again until
it is partly ejected.
V. 02 – 26/09/2018
CAMCOLVC26N
7 ©Velleman nv