Battery Installation; Thermostat Installation - Perel CTH406 Manual Del Usuario

Display
1 low bat indicator
2 24 hour bars
3 comfort mode
4 eco mode
6. Installation
6.1

Battery Installation

Do not puncture batteries or throw them in
fire as they may explode. Do not attempt to
(alkaline). Dispose of batteries in accordance
with local regulations. Keep batteries away
1. Remove the front cover using an appropriate screwdriver.
2. Insert two LR6/AA batteries according to the polarity markings.
3. Replace both batteries with new ones as soon as the low bat
indicator is displayed.
4. Proceed with installing the thermostat.
6.2

Thermostat Installation

Make sure to cut off the mains power supply
1. Choose your installation spot. Install the thermostat in a well-
ventilated place and about 1.5 m (5 feet) above the floor, away
from direct sunlight, heat and interference sources.
2. Mount the thermostat on a flat surface. Drill two 6 mm holes and
insert a nylon anchor plug in each hole. Drill two 2.6 mm holes
when mounting the thermostat on a wooden surface.
3. Wire the thermostat. The thermostat is designed for maximum
230 V~, 6 A. Never exceed these limits!
Use wires with diameter of 1.0-2.5 mm² and connect
accordingly.
Refer to the illustrations on page 3 of this manual.
V. 02 – 23/02/2018
CTH406
WARNING
recharge non-rechargeable batteries
from children.
WARNING
before installing the thermostat.
5 holiday mode
6 cooling
7 manual override
8 heating
6 ©Velleman nv