LEGRAND 430 521 Manual De Usuario página 23

DIP SWITCH SETUP
Before installing the camera, set up the DIP switch to configure the camera ID and the communication protocol.
• Product & Accessories
• Camera ID Setup
• DID numbers of cameras are set up with binary numbers. See the examples shown below.
Pin
Binary Value
ex: ID = 5
ex: ID = 10
• The camera ID range is "1~255".
• The factory default of the camera ID is "1".
• Match the camera ID with the Cam ID setting of your DVR or Controller to control the camera.
• If you are connecting a single camera to a controller, terminate the camera. When connecting more than one
camera to a single controller, terminate the last camera on the communication line. The last camera means
the camera farthest in cable length from the controller.
• Note that the total length of the communication cable between a controller and the camera(s) on the same
communication line must be less than 1.2Km.
1 2 3
1 2 4
on off on
off on off
Camera ID must not be "0"!
4 5 6
8 16 32
off off off
on off off
23
7 8
64 128
off off
off off