Operating Instructions; Paddle Switch (Fig. 21); Slide Switch (Fig. 23) - Bosch GWX13-50 Instrucciones De Funcionamiento Y Seguridad

Never leave the trigger
locked
plugging the tool in, check that the trigger
lock is "OFF". Accidental start-ups could
cause injury.
Be aware of the loca-
tion and setting of the
switch "Lock-ON" button. If the switch is
locked "ON" during the use, be ready for
emergency situations to switch it "OFF".
Do not use the switch
"Lock-ON" feature in
situations where kickback is likely, such
as when working into a corner. When the
wheel binds, the tool will kick-back in op-
posite direction of wheel rotation and the
release of the trigger "Lock-ON" may be
difficult.
If the "Lock-ON" button
is
depressed, the trigger cannot be re-
leased.

▶ Paddle Switch (Fig. 21)

The paddle switch has a Lock-OFF feature
to help prevent accidental startups. TO
TURN TOOL "ON", push Lock-Off switch
backward to unlock the paddle switch,
then squeeze paddle switch. TO TURN
TOOL "OFF", release pressure on paddle
switch. The switch is spring loaded and
will return to the "OFF" position automati-
cally.
If your tool has the Lock-ON feature incor-
porated into the paddle switch for extend-
ed operation, there will be a red button on
the bottom of the tool directly behind the
paddle switch, Fig. 22. TO LOCK SWITCH
"ON" after paddle switch has been acti-
vated, push "Lock-ON" button while simul-
taneously releasing pressure from the pad-
dle switch. TO TURN TOOL "OFF", squeeze
and release paddle switch.

▶ Slide Switch (Fig. 23)

TO TURN TOOL ON, press the back of the
switch and slide it forward towards the
gear housing until it comes to a stop and
1600A019ZE 05-19 GWX13.indd 24

Operating Instructions

"ON". Before
continuously being
Fig. 21
Paddle Switch
Fig. 22
Fig. 23
the motor starts running. For Lock-ON,
when the switch is in the ON position,
press the front of the switch and release
it. the switch should remain in the Lock-
ON position and the tool will continue to
run.
TO TURN TOOL "OFF", press the rear por-
tion of the switch. The switch is spring
loaded and will return to the "OFF" posi-
tion automatically.
-24-
ON
OFF
Lock-ON Button
Side
Switch
5/28/19 3:15 PM