General Guidelines - Perel AJS2T-2 Manual Del Usuario

• Do not attempt to enter the vehicle and ensure all passengers are out of the vehicle when
loading it on these stands.
• Take care when using on a three-wheeled vehicle or trailer.
3.

General Guidelines

• Refer to the Velleman
• All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will
void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
• Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession,
use or failure of this product.
• Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
5. Operation
Before First Use
Place the ratchet bar into the lower support frame. Bend the locking bar tab inwards using a
blunt-ended tool and hammer. When lifted by the ratchet bar, they should not separate.
Inspection Before Each Use
Visual inspection should be made before each use of the axle stands. Check for cracked welds
and damaged, loose or missing parts. Any axle stand, which appears to be damaged in any
way, found to be badly worn, operates abnormally, or has been subjected to an abnormal load
or shock, must not be used.
Use – To Support the Vehicle
1. Adjust the height by pulling up on the ratchet bar ensuring the ratchet stop is fully
engaged.
2. Insert the locating pin through the holes in the lower column.
3. Raise the vehicle and carefully position the ratchet axle stands so that the load is centred
on the stand's saddle.
4. Slowly lower the vehicle onto the stands - securely chock wheels remaining on the ground.
5. Before starting work ensure the vehicle is fully secure.
• The stands must be positioned on a hard level surface e.g. concrete.
• The safe working load must not be exceeded under any circumstances.
• Centre the load on the saddle.
• Use as a pair to support one end of a vehicle only.
V. 01 – 12/07/2019
® Service and Quality Warranty on the last pages of this manual.
ratchet bar
lower support frame
locking tab
AJS2T-2
4
5
6
4
ratchet release handle
safety pin
top saddle
©Velleman nv