Tabla de contenido
Publicidad
per day.
immediately discontinue use and see your doctor about these
symptoms.
WARNING
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 83.
1. Front handle, insulated gripping surface
2.
3.
4. Lock on button
5. Main handle, insulated gripping surface
6.
7.
8. Trigger
9. Sanding belt release lever
10. Sanding belt
MAINTENANCE
WARNING
The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
chips and grindings are highly abrasive to bearings,
2
| English
brushes and commutators. The manufacturer does not
time on these types of materials.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer
or its service agent. Contact the authorised service
centre.
For greater safety and reliability, all repairs should be
performed by an authorised RYOBI service centre.
LUBRICATION
amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
CLEANING THE SANDING BELT
The sanding belt that came with your sander is made to
be re-used. Therefore, it is important that it be cleaned
periodically to remove sanding residue and foreign material
that can accumulate over time. One of the ways to clean
sanding belt is to rub the sheets with a hard rubber block.
You can also use the clean rubber sole of a shoe.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOL
Safety Alert
V
Volts
Hz
Alternating current
W
Watts
n
No-load speed
o
Revolutions or reciprocations per minute
CE Conformity
EurAsian Conformity Mark
Publicidad
Tabla de contenido
