Assembly And Adjustments - Sears Craftsman CMCST910 Manual De Instrucciones

DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING:
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.
Installing the Guard (Fig. B, C)

WARNING:
Damage or personal injury could result.

WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
1. Remove the guard screw
2. Slide the guard fully onto the trimmer head
9
Make sure the tabs on the guard engage the ribs on
20
the trimmer head.
3. Continue to slide the guard on until it "snaps"into place.
The locking tab should snap into the housing slot.
4. Using a crosshead screwdriver, insert the guard screw
and tighten securely.
5. Once the guard is installed, remove the covering from
the line cut-off blade, located on the edge of the guard.
Fig. B
To reduce the risk of
Never remove the guard.
NEVER OPERATE
.
19
.
18
18
19
Fig. C
9
Adjusting the Auxiliary Handle (Fig. D)
The auxiliary handle is positioned to maximize balance.
4
However, if adjustment is necessary, flip open the latch
and slide the auxiliary handle
trimmer pole 6 .
Fig. D
6
Releasing the Cutting Line (Fig. A)
In transit, the cutting line is taped to the spool housing
• Remove the tape holding the cutting line to the
spool housing.
OPERATION

WARNING:
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.

WARNING:
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.
English
20
21
4 up or down the upper
21
4
10
To reduce the risk of
Always use proper eye
.
7