Measurement.oPeration - Beta 1760 Manual De Uso

MEASUREMENT OPERATION:
1 Hold the meter by its Handle Grip and point it toward the surface to be measured.
2 Pull.and.hold.the.Trigger.to.turn.the.meter.on.and.begin.testing..The.display.will.light.if.the.
battery.is.good..Replace.the.battery.if.the.display.does.not.light.
3 While. measuring,. the. SCAN. display. icon. will. appear. in. the. upper. left. hand. corner. of. the.
LCD.
4 Release the Trigger and the HOLD display icon will appear on the LCD indicating that the
reading.is.being.held.
5 The.meter.will.automatically.power.down.after.approximately.7.seconds.after.the.trigger.is.
released.(Unless the unit is locked on)
Note: Measurement considerations
Holding the meter by its handle, point the IR Sensor toward the object whose temperature is to be
measured..The.meter.automatically.compensates.for.temperature.deviations.from.ambient.tempe-
rature. Keep in mind that it will take up to 30 minutes to adjust. Where wide ambient temperatures
are to be measured followed by high temperature measurements, some time (several minutes) is
required after the low (and before the high) temperature measurements are made.
This is a result of the cooling process, which must take place for the IR sensor.
0