Basic Operation; Troubleshooting - Teac CG-10M Manual Del Usuario

Basic operation

1
Shift the POWER switch to its ON position to
turn the unit on.
o It takes two minutes for the oscillation frequency of the crys-
tal oscillator (OCXO) to stabilize.
V
When not using the unit for a long time, set
its POWER switch to OFF.
2
Start playback on a connected device.
Confirm that clock input has been locked on the receiving
device. For details about how to do this, see the operation
manual for the device receiving clock input.
8

Troubleshooting

If you experience a problem with this unit, please take a moment to
review the following information before requesting service. If it still
does not operate correctly, contact the retailer where you purchased
the unit.
General
The unit does not turn on.
e Check that the power cord is completely plugged into the
power outlet. If the outlet is switched, confirm that the switch
is in the ON position.
e Connect a different electrical device to the outlet to confirm
that it is supplying power.
No sound is output.
e Reconfirm the connections with other equipment.
There is a humming noise.
e If a connecting cable is near a power cord, fluorescent light or
similar cause of interference, increase the distance between
them as much as possible.
The clock output is not synchronizing another
device.
e Confirm that the connected device supports 0.5Vrms 10MHz
clock.
Clock signals that can be input and synchronized might vary
according to how each device is connected and set. Refer to
the operation manuals of the connected devices.