Safety Labels; Guidelines For The Operator; Transporting The Machine; Preparing For Use - Tennant 250 Manual Del Operario

The power supply cord must be regularly inspected for

signs of damage. If the power supply cord is damaged,
it must be replaced.
Take care when using a machine near the top of stairs

to avoid over balancing.
Do not stack dryers more than two units high without

tie- downs.

1.2 Safety Labels

The safety labels appear on the machine in the locations
indicated. Replace labels if they are missing or become
damaged or illegible.
FOR SAFETY: Read
manual before
operating machine.
WARNING: Electrical Hazard. Do
Not Operate With Damaged Supply
Cord. Do Not Modify Plug. Unplug
Supply Cord Before Servicing Machine.

1.3 Guidelines for the Operator

Operators must be fully trained in the use of the machine in
accordance with these instructions, able to perform user
maintenance and the correct selection of accessories.
Operators should be physically capable to maneuver,

transport and operate the machines.
Keep machine clean and in good operating condition.

Operators should be able to recognize unusual

operation of the machine and report any problems.
Wear suitable footwear to avoid slipping.

Wear suitable clothing to keep dry and warm.

Do not smoke when using the machine.

CAUTION- For indoor use only. Do not use outdoors or
expose to rain.

1.4 Transporting the Machine

CAUTION - THIS MACHINE IS HEAVY
Incorrect lifting techniques may result in personal injury. Carry
by the handle on top of the machine. Do not carry the machine
when it is running.
Tennant 250 (08- 07)

2. Preparing for use

2.1 Electrical Connection

Before connecting the machine to the power supply, check that
your supply voltage corresponds with that marked on the rating
label on the machine. Do Not use an extension cord with this
machine.
IMPORTANT: If the supply cord is damaged or broken, it must
be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
WARNING - THIS APPLIANCE MUST BE GROUNDED

3. Components

2
1
6

4. Operation

1. Select suitable location for dryer.
IMPORTANT- Ensure dryer is in a safe position. Do not sit
dryer in a puddle and make sure it is protected from drips
and splashes.
2. Fully unwind the supply cord from the cable winder and
plug into a convenient socket outlet.
3. Place the dryer in the desired operating position.
- Horizontal - dry floors and carpets.
- Tilted - dry floor finishes, paint etc.
- Vertical - dry wall and ceiling.
4. Set the desired speed by turning switch.
5. Check for proper operation before leaving the unit
unattended. Do not move or carry the dryer when it is
running.
6. To stop the machine turn switch to off (O).

5. Storage

Always unplug and wipe down and dry the machine after use.
Wrap supply cord around the cable winder ensuring that the
plug is not trailing on the floor. Store the machine in a dry
indoor area only.
English
3 1. Three Speed Switch
2. Carrying Handle
3. Cable Winder
4
4. Supply Cord
5. Air Outlet Vent
6. Air Intake Vent
7. Kick Stand
5
7
EN
3