Product Safety Instructions; Important Notice Concerning Power Cord Selection; Fcc Compliance Statement - Westinghouse TX-42F430S Manual Del Usuario

1. PRODUCT SAFETY
WARNING: This device must be operated with the original power supply, part number DPS-210
EP 2 C.
CAUTION: The power supply outlet should be located near High Definition LCD TV and should
be easily accessible. Always use the appropriate AC cord that is certified for your specific country.
Some examples are listed below:
USA..................UL
Canada.............CSA
Germany..........VDE

IMPORTANT NOTICE CONCERNING POWER CORD SELECTION

The specific power cord for this High Definition LCD TV is enclosed and has been selected
according to the country of destination and must be used to prevent electric shock. Use the
following guidelines if it is necessary to replace the original cord set, or if the cord set is not
enclosed. The female receptacle of the cord set must meet IEC-60320 requirements and should
look like Figure A1 below:
Figure A1
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and
CSA Labeled. For High Definition LCD TVs that are placed on a desk or table, type SVT or SJT
cord sets may be used. For High Definition LCD TVs placed directly on the floor, only SJT type
cord sets may be used. The cord set must be selected according to the current rating for the High
Definition LCD TV. Please consult the table below for the selection criteria for power cords used
in the United States and Canada.
Cord Type
SJT
SVT

FCC Compliance Statement

This equipment has been tested and complies with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and may cause harmful interference to radio communications if not
installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the High Definition LCD TV and receiver.
P L E A S E R E A D
P L E A S E R E A D
P L E A S E R E A D
Switzerland ..... SEV
Britain ............. BASE/BS
Japan ............... Electric Appliance Control Act
Figure A2
Size of Conductors in Cord
18 AWG
16 AWG
14 AWG
18 AWG
17 AWG
6
F I R S T :
F I R S T :
F I R S T :
Maximum Current Rating of
Unit
10 Amps
12 Amps
12 Amps
10 Amps
12 Amps