Sears Craftsman 358.791170 Manual De Uso página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Always release the throttle trigger and
allow the engine toreturn toidle
speed w hen n ot c utting.
HOW TOSTOP Y OUR U NIT
• Release the throttle trigger.
• Push a nd release the engine ON/
STOP switch.
CUTTING
METHODS
,_WARNING:
Use minimum
speed and do not crowd the line when
cutting around hard objects
(rock,
gravel, fence posts, etc.), which can
damage
the trimmer head, become
entangled in the line, or be thrown
causing
a serious
hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum
line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of line does the
Right
Line crowded into
work_
Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
• For trimming
or scalping,
use less
than full throttle to increase
line life
and decrease
head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact with vegetation.
Do not force
trimmer line into work area.
Trimming
SCALPING
- The scalping technique
removes unwanted vegetation down to
the ground. Hold the bottom of the trim-
mer head about 3 inches (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments,
etc.
This technique increases line wear.
Scalping
MOWING
- Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing
the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING - The fanning action of the
rotating line can be used to blow away
loose debris from an area. Keep the line
parallel to and above the area surface
and swing the tool from side to side.
Sweeping
3 inches
(8 cm) abow
ground
15

Publicidad

Tabla de contenido
loading

Tabla de contenido